FT-260 Zen Oval Fountain
Assembly Instructions
Step 5 - Firmly press the stopper into the hole while pulling the cord the remainder of the way.
5a - Use the handle of the screwdriver to press the stopper down as far as possible.
See image “C”.
Step 6 - Fill the basin enough to cover the pump completely with water to check for leaking.
6a - If leaking occurs…
- Remove the stopper and repeat step 5 again.
- Use some of the excess putty to seal the cord around the top of the stopper.
See image “D”.
- Let the fountain dry completely, then use 100% clear silicone to seal around the
pump cord and perimeter of the stopper. Silicone must set for 24 hours before
adding water.
Step 7 - Holding the water feature (FT-260A) over the basin (FT-260B), insert the CPVC end of the
tubing into the coupling protruding from the bottom.
Step 8 - Center the water feature (FT-260A) into basin (FT-260B).
Step 9 - Connect the pump cord to the transformer.
C
D
FT-260A (3 lbs)
13"L x 8.25"W x 1.5"H
