FT-132 Williamsburg Pineapple 2-Tier Fountain
Two people are recommended for the installation of this fountain!
Revised March 11, 2017
Assemble your fountain on a level surface capable of holding a minimum of 331 pounds with an approximate 1 square foot footprint.
FT-132G (135 lbs)
12.75”W x 25.75”H
FT-132F (111 lbs)
30”W x 8.5”H
FT-132D (7 lbs)
7.5”W x 5.5”H
FT-132C (11 lbs)
7”W x 9”H
FT-132B (20 lbs)
16.5”W x 4.5”H
FT-132A (3 lbs)
3.75”W x 7”H
FT-132E (1 lb)
4.75”L x 1.5”W x 4”H
1.
Place the base (FT-132G) into position where the fountain will be installed, ensuring that
it is level.
a.
Note: Check that all components are leveled as the fountain is assembled.
2.
Position the large bowl (FT-132F) over the base (FT-132G).
3.
Assemble the fountain plumbing
a.
Attach the 1/2” non-kink tubing to the pump outlet.
b.
Place a hose clamp over the other end of the 1/2" non-kink tubing
c.
Place the stopper around the pump cord approximately 8” from the pump.
4.
Feed the pump cord all the way through the hole in the large bowl (FT-132F), through the
base (FT-132G).
5.
FIRMLY
press the stopper into the hole evenly.
a.
Note: Using the handle of a screwdriver or hammer works best to press the
stopper in place.
6.
Place the pump cover (FT-132D) over the pump.
7.
Place the small pedestal (FT-132C) over the pump cover (FT-132D).
8.
Feed the tubing through the hole in the center of the small pedestal (FT132C).
9.
Position the small bowl (FT-132B) over the small pedestal (FT-132C).
10.
Connect the 1/2" non-kink tubing to the pipe protruding from the bottom of the small
bowl (FT-132B) with the hose clamp.
11.
Fit the finial (FT-132A) into the small bowl (FT-132B) by feeding the protruding copper
pipe from the bowl into the copper pipe hole in the finial.
12.
Place the pump cover door (FT-132E) into the pump cover (FT-132D).
13.
Fill the fountain with water.
