FT-377 St Helena Fountain
Assembly Instructions
Assemble your fountain on a level surface capable of holding a minimum of 25 lbs with
an approximate 0.5 sq. ft. footprint (actual dimensions 7" Diam.).
Step 1 -
Assemble the pump kit:
1a – Do not connect the pump to the transformer until assembly is complete.
1b -
Using a hose clamp and screwdriver, attach the 1/2" end of the non-kink tubing to
the pump adapter.
Step 2 -
Place the pump flat on its side in the bottom of the bowl (FT-377B).
Step 3 -
Feed the pump cord through the channel cut in the top lip of the fountain bowl, so the
cord hangs down the back of the fountain.
Step 4 -
Insert the CPVC end of the tubing assembly into coupling on the bottom of the water
feature (FT-377A).
Step 5 -
Place the water feature (FT-377A) on top of the basin (FT-377B) making sure that it
is level.
5a -
Note: Rotating the disc while lowering it onto the basin will coil the non-kink tubing
inside the basin and help the disc to sit flat.
Step 6 -
Connect the pump cord to the transformer.
Step 7 -
Fill the fountain with water.
FT- 377B (12 lbs)
12.25"W x 6"H
Fountain Set-Up:
Assembly & Installation -
A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help:
Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation:
Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop:
To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet:
Use only a GFCI outlet when running a fountain.
FT- 377A (5 lbs)
10.5"W x 2"H
