FT-270 Monteros in Basin Fountain
Professional installation is recommended for this fountain! Assemble your fountain on a level surface using crushed stone, gravel, or
cement pad as the base.
Revised August 28, 2017
FT-269B (40 lbs)
20.25”W x 7”H
FT-269A (22 lbs)
5.5”W x 12.5”H
FT-269D (3 lbs)
5”L x 1.5”W x 4.5”H
FT-269G (5 lbs)
6.25”L x 1.5”W x 5.25”H
FT-269I (15 lbs)
7.75”L x 1.5”W x 7”H
FT-124K (282 lbs each)
38”L x 9”W x 15”H
21.
Place a hose clamp over the other end of the 12” length of 1/2” non-kink tubing.
22.
Connect that end of the tubing to the bottom of the small bowl (FT-269B). Tighten the
hose clamp to ensure a good seal.
23.
Place the small bowl (FT-269B) on top of the small pedestal (FT-269c.
24.
Place the finial (FT-269A) in the small bowl (FT-269B) by lowering the hole over the
copper pipe protruding from the bowl.
25.
Cover the small pedestal pump access with the pump cover door (FT-269D).
26.
Cover the medium pedestal pump access with the pump cover door (FT-269G).
27.
Cover the base pump access with the pump cover door (FT-269I).
28.
Place 1 piece of coping (FT-124K) directly against the fiberglass basin (FGB-2020).
29.
Place 1 wood spacer against the bottom outer edge of the first piece of coping.
a.
Leave about 1 inch of the spacer sticking out for easy removal.
30.
Position the second coping against the wood spacer and basin.
31.
Repeat steps 29 and 30 until only 1 piece of coping is not in place. There should be a
gap between copings where the inside corners meet.
32.
Insert 1 plastic wedge about 3 inches from each edge of the 7 copings already installed.
(This reduces the gap in the inner circle of the coping.)
33.
Carefully push the final piece of coping into place and place the 2 wedges under
a.
Adjust the other copings as needed to form a circle.
34.
Remove the wood spacers.
35.
Fill the basin with water.
