FT-379 Mondrian Fountain
Assembly Instructions
Two people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 585 lbs with
an approximate 2 sq. ft. footprint (actual dimensions 18.75"L x 15.25"W).
Step 1 -
Stand up the water feature (FT-379B) placing it into position where the fountain will be
installed.
1a -
NOTE - If placing against a wall leave enough space to pass your hand behind it. The
fountain can be moved back after pump installation is completed and the cord has
been run behind the fountain.
Step 2 -
Center the basin (FT-379D) in from of the water feature (FT-379B), but do not fit into
water feature yet.
Step 3 -
Assemble the pump kit:
3a -
Using a hose clamp, attach the 1/2" non-kink end of Tubing Assembly #1 to the
pump outlet.
3b -
Place the stopper around the pump cord approximately 6" from the pump.
Step 4 -
Feed the pump cord through the large hole in the back of the basin (FT-379D).
Step 5 -
FIRMLY press the stopper into the hole evenly.
Step 6 -
Insert the CPVC end of the Tubing Assembly #1 into the 1/2" CPVC coupling inside the
basin (FT-379D).
Step 7 -
Take Tubing Assembly #2 and insert one end to the CPVC coupling in the back of the
basin (FT-379D) and the top of the cut out in the back of the feature (FT-379B).
Step 8 -
Push basin into position in the hole.
8a -
NOTE – The basin will only go up to a 1/4" inside water feature hole.
Step 9 -
Check sides of basin so that gaps on both sides against water feature are even.
Step 10 -
Insert the drain stopper (DRAIN-7) into the drainage hole.
FT-379B (279 lbs)
35"L x 3.75"W x 34.5"H
Fountain Set-Up:
Assembly & Installation -
A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help:
Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation:
Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop:
To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet:
Use only a GFCI outlet when running a fountain.
FT-379D (183 lbs)
28"L x 14"W x 15"H
