M-101 Modular Fountain Insert
Assembly Instructions
Assemble your fountain on a level surface capable of holding a minimum of 90 lbs with an
approximate 3 sq. ft. footprint (actual dimensions vary depending on modular planter used).
Step 1 - Position the Modular Planter where the fountain is to be installed, ensuring that it will
be level.
Step 2 - Assemble the pump kit:
2a - Using a hose clamp and screwdriver, attach the 1/2” non-kink tubing to the pump
outlet.
2b - Place the stopper around the pump cord approximately 6 inches from the pump.
Step 3 - Feed the pump cord through the hole in the base of the desired modular planter leaving
enough cord length inside basin to work with the pump.
Step 4 - Firmly press the stopper into the hole while pulling the cord the remainder of the way.
4a - Note: Using the handle of a screwdriver or hammer works best to press the stopper
in place.
Step 5 – Center the pump house (M-101B) into the modular planter.
5a – Ensure that the pump is sitting within the pump house.
Step 6 – Using a hose clamp and screwdriver, secure the other end of the 1/2” non-kink tubing to
the copper pipe protruding from the bottom of the water feature (M-101A).
Step 7 - Center the water feature (M-101A) onto pump house (M-101B).
Step 8 – Fill the fountain with water.
M-101A (17 lbs)
10" Sq. x 2.5"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
M-101B (30 lbs)
8.5" Sq. x 10.5"H