FT-49 Rustica Pot Fountain
Assembly Instructions
Two people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 183 lbs with an
approximate 3/4 sq. ft. footprint (actual dimensions 10" diam.).
Step 1 - Position the basin (FT-49B) where the fountain is to be installed, ensuring that it is level.
Step 2 - Assemble the pump kit:
2a - Using a hose clamp, attach the 1/2" non-kink end of the tubing assembly to the pump
outlet.
2b - Place the stopper around the pump cord about 6" from the pump.
Step 3 - Feed the pump cord all the way through the hole and the channel in the basin (FT-49B) to
ensure the fountain will be level.
Step 4 - FIRMLY press the stopper into the hole evenly.
4a - Note: Using the handle of a screwdriver or hammer works best.
FT-49B (115 lbs)
20.5"W x 17.5"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Step 5 - Holding the water feature disc (FT-49A) over the basin (FT-49B), insert the CPVC end of
the tubing assembly into the coupling protruding from the bottom of the disc.
Step 6 - Center the water feature (FT-49A) into the basin (FT-49B).
Step 7 - Fill the fountain with water.
FT-49A (34 lbs)
15.25"W x 2.25"H
