FT-387 Fountain
Assembly Instructions
Three people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 1035 lbs with
an approximate 3 sq. ft. footprint (actual dimensions 20.5" x 20.5").
Step 1 -
Place the base (FT-387G) into position where the fountain will be installed, ensuring that
it is level.
1a - Note: Check that all components are leveled as the fountain is assembled.
Step 2 -
Position the large pedestal (FT-256F) over the base (FT-387G).
Step 3 -
Center the large bowl (FT-256E) over the large pedestal (FT-256F).
Step 4 -
Assemble the fountain plumbing:
4a -
Attach the clear end of the tubing assembly to the pump outlet.
4b -
Place a hose clamp over the other end of the 1/2" non-kink tubing.
4c -
Place the stopper around the pump cord approximately 8" from the pump.
Step 5 -
Feed the pump cord all the way through the hole in the large bowl (FT-256E), through
the large pedestal (FT-256F), and out of the opening in the bottom of the base (FT-387G).
Step 6 -
FIRMLY press the stopper into the hole evenly.
6a -
Note: Using the handle of a screwdriver or hammer works best to press the stopper
in place.
Step 7 -
Insert the #7 Drain Stopper into the small drain hole.
FT-387G (215 lbs)
20.5"W x 8"H
Fountain Set-Up:
Assembly & Installation -
A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help:
Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation:
Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop:
To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet:
Use only a GFCI outlet when running a fountain.
FT-256F (217 lbs)
15.75"W x 28.5"H
FT-256E (308 lbs)
46.5"W x 10"H
