rev 4/8/2020
FT-304 Westover Fountain
Assembly Instructions
Two people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 289 lbs with an
approximate 1 sq. ft. footprint (actual dimensions 11.5" x 11.5").
Step 1 - Place the base (FT-77E) into position where the fountain will be installed ensuring that it
is level.
FT-77E (114 lbs)
11.5"L x 11.5"W x 21.25"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Step 2 - Assemble the pump kit:
2a - Using a hose clamp, attach the 1/2" non-kink tubing to the pump outlet.
2b - Place the stopper around the pump cord about 6" from the pump.
Step 3 - Center the large bowl (FT-77D) over the base (FT-77E).
Step 4 - Feed the pump cord through the hole in the large bowl (FT-77D) and the channel in the
base (FT-77E).
Step 5 - FIRMLY press the stopper into the hole evenly.
5a - NOTE: Using the handle of a screwdriver or hammer works best.
FT-77D (96 lbs)
28.5"W x 10.75"H
Step 6 - Place the pump house (FT-304C) over the pump and in the center of the large
bowl (FT-77D).
Step 7 - Feed the non-kink tubing through the top of the pump house (FT-304C).
FT-304C (5 lbs)
7.25"W x 7"H
