FT-240 Three Tier Longvue Fountain
Three people are recommended for the installation of this fountain!
Revised April 6, 2017
Assemble your fountain on a level surface capable of holding a minimum of 1052 pounds with an approximate 2.75 square foot footprint.
FT-239J (242 lbs)
20”L x 20”W x 12”H
FT-239I (141 lbs)
15.75”W x 18.5” H
FT-239H (465 lbs)
48”W x12”H
FT-239F (59 lbs)
12.75”W x 14.25”H
FT-239E (210 lbs)
36.5”W x 10”H
FT-239C (28 lbs)
9.25”W x 13.5”H
FT-225B (55 lbs)
21.5”W x 6.75”H
FT-239A (14 lbs)
5.5”W x 13.5”H
FT-239D&G (2 lbs)
Pump house doors
1.
Place the base (FT-239J) into position where the fountain will be installed, ensuring that it is level.
a.
Note: Check that all components are leveled as the fountain is assembled.
2.
Center the large pedestal (FT-239I) over the base.
3.
Assemble the fountain plumbing
a.
Attach the 3/4” clear tubing attached to the non-kink tubing to the pump outlet.
b.
Place the stopper around the pump cord approximately 8” from the pump.
4.
Center the large bowl (FT-239H) over the large pedestal (FT-239I) making sure the holes line up.
5.
Feed the pump cord all the way through the holes in the bowl (FT-114F) and pedestal (FT-239I) then
out of the access door in the base (FT-239J).
6.
FIRMLY
press the stopper into the hole evenly.
a.
Note: Using the handle of a screwdriver or hammer works best to press the stopper in place.
7.
Position the medium pedestal (FT-239F) over the pump in the large bowl (FT-239H).
8.
Feed the non-kink tubing connected to the pump through the top of the medium pedestal (FT-239F).
9.
Center the medium bowl (FT-239E) over the medium pedestal (FT-239F).
10.
Insert the standpipe into the middle bowl (FT-239E).
a.
Feed the fountain tubing through the stand pipe as it is fixed into the bowl.
11.
Position the small pedestal (FT-239C) over the center of the medium bowl (FT-239E).
12.
Feed the non-kink tubing through the hole in the center of the small pedestal (FT-239C).
13.
Using a hose clamp, secure the loose end of the non-kink tubing to the pipe protruding from the
bottom of the small bowl (FT-225B).
14.
Center the small bowl (FT-225B) over the small pedestal (FT-239C).
15.
Fit the finial (FT-239A) into the small bowl (FT-225B) by feeding the protruding copper pipe from the
bowl into the hole in the bottom of the finial.
16.
Place the small pump cover door (FT-239D) into the small pedestal (FT-239C).
17.
Place the large pump cover door (FT-239G) into the medium pedestal (FT-239F).
18.
Fill the fountain with water.
