Fountain Components
Image
Item Description
Component
Item #
Quantity
Recife Oval
Water Feature
Bowl
FT-103A
1
Recife Pump
House
FT-103B
1
Recife Door for
Pump House
FT-103C
1
Recife
Rectangle Basin
FT-103D
1
FT-103 Recife Fountain
Assembly Instructions
rev 3/30/2020
Fountain Information:
• This fountain holds approximately 20 gallons of water.
• This fountain uses a medium fountain cover: FTNCOV-MED
• Compatible with Refill #10 Device and LED Kits
• (A special stopper is required to use the refill kit for this fountain)
Pump Information:
OEMPF5320 - 1320 GPH Pump 16 FT cord length
Tools Required:
Bubble Level
Screwdriver
Pump Kit Parts List
Image
Component
Quantity
PK300 Pump
(use adapter indicated)
1
#10 Stopper
1
Approx. 10" length of 1/2" black
non-kink tubing
1
Approx. 2" length of 5/8" clear vinyl
tubing
1
Approx. 2" length of 1/2" CPVC pipe
1
Approx. 6.75" length of 1/2" Copper
pipe
1
Wedges
2
Hose Clamps
1
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Proudly
MADE IN USA
