FT-280 Condotti Fountain
Three people are recommended for the installation of this fountain!
Revised July 19, 2018
Assemble your fountain on a level surface capable of holding a minimum of 1200 pounds with an approximate 4 square foot footprint.
FT-269H (392 lbs)
24”L x 24”W x 15”H
P-713 (500 lbs)
46”W x 25.25”H
FT-224D (56 lbs)
12”W x 8”H
FT-280A (10 lbs)
12”W x 5”H
FT-224E (2 lbs)
6”L x 2.5”W x 4.75”H
FT-269I (13 lbs)
8.25”L x 2.5”W x 9”H
1.
Place the base (FT-269H) into position where the fountain
will be installed, ensuring that it is level.
2.
Assemble the pump kit
a.
Connect the preassembled tubing to the pump by
sliding the 3/4" clear tubing over the pump outlet.
b.
Place the stopper around the pump cord about 8”
from the pump.
3.
Center the urn (P-713) over the base (FT-269H).
4.
Feed the pump cord through the hole in the urn (P-713)
and the channel in the base (FT-269H).
5.
FIRMLY
press the stopper into the hole evenly.
6.
Insert the smaller drain stopper into the small hole of the
bowl.
7.
Place the pump house (FT-224D) over the pump and in
the center of the urn (P-713).
8.
Position the water feature disc (FT-280A) over the pump
house (FT-224D).
9.
Insert the 1/2" CPVC end of the preassembled tubing into
the coupling protruding from the bottom of the water
feature disc (FT-280A).
10.
Fit the small pump house door (FT-224E) into the pump
house (FT-224D).
11.
Fit the large access door (FT-269I) into the base (FT-
269H).
12.
Fill the fountain with water.
