FT-120 Andalusia Fountain
Professional installation is recommended for this fountain!
Revised October 15, 2019
Pump Kit Parts List
PK300 pump (1)
LED-LIGHT (1)
LED-TRANS (1)
#5 wing nut drain stopper (1)
#7 wing nut drain stopper (1)
Approx. 20” length of 1/2” Black non-kink tubing (1) **
Approx. 2” length of 5/8” clear vinyl tubing (1) **
Approx. 2” length of 1/2” CPVC pipe (1)
Approx 42” length of 3/8” galvanized pipe (2)
10oz tube of silicone (1)
Hose clamps (1) *
Wedges (2)
* Hose clamps may be used as flow restrictors
**Black non-kink tubing and clear vinyl tubing have been preassembled
***
Do not preassemble the LED Light and Transformer
- W I N T E R C A R E -
Fountain bowls/tops and other fountain components, which collect water, should not be left outside in the winter since
any component, which fills with water and freezes may crack. Likewise, components such as pedestals, which remain in a
basin, filled with water, which then freezes, may also crack or crumble. Ideally, therefore, a fountain should always be
stored indoors or in a dry protected place such as a covered porch away from the elements. However, if a fountain must be
left outside:
(1) Remove pump, rubber stoppers, drainpipes, finials, and other small components for storage indoors. Note that
stoppers or drainpipes are removed to allow drainage in the event water accumulates in any basin.
(2) Raise fountain base from ground with wood strips so that base will not freeze to the ground surface.
(3) Cover or wrap the fountain with burlap or other absorbent material (old blanket or towel) and then cover securely
with plastic, making sure that water will not accumulate in the basin or other fountain component and freeze;
(4) Check fountain periodically to ensure that plastic is secure and water is not accumulating in any fountain
component.
- G E N E R A L F O U N T A I N T I P S -
Install fountains on a level surface.
You will need a properly grounded 110-volt (AC only) GFCI protected receptacle
near the fountain for your pump. All pumps are submersible and must be completely underwater to function properly.
Test all pumps and adjust to full output prior to assembly. It is not recommended that fountains be placed directly on grass
or dirt. Position the channel opening at the base of each fountain toward the
electrical outlet to be used since the pump cord will be threaded through this
opening.
Check out YouTube for a “How to” video.
For more Campania product information visit www.campaniainternational.com
All of our cast stone is proudly
FOUNTAIN INFORMATION:
This fountain holds approximately 60 gallon of water.
This fountain does not fit under a Campania fountain
cover.
Compatible with #10 Refill Device and LED Kits
(No stoppers are required to use the refill kit or LED
kit for this fountain.)
TOOLS REQUIRED:
Bubble Level
Caulking Gun
Hammer
PUMP INFORMATION:
OEMPF320 - 320 GPH Pump
16 FT cord length
