FT-120 Andalusia Fountain
Assembly Instructions
Professional installation is recommended for this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 2200 lbs with an
approximate 13.5 sq. ft. footprint (actual dimensions 56" x 29.75").
Step 1 - Place the base (FT-120C) into position where the fountain will be installed, ensuring that
it is level.
Step 2 - Using a caulking gun, run a bead of silicone along the top of the basin (FT-120C) where
the water feature (FT-120A) will be placed. Take care not to use too much silicone to
minimize oozing of silicone from between the pieces.
FT-120C (1080 lbs)
56.25"L x 30"W x 17.5"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Step 3 - Place the water feature (FT-120A) on top of the basin (FT-120C) making sure that the PVC
pipe holes are lined up between the top of the basin and the bottom of the water feature.
NOTE -
BE CAREFUL NOT TO PINCH FINGERS WHEN LOWERING! Hand holds have been
molded into the water feature for easier assembly.
Step 4 - Clean off any excess silicone with your finger or a dry rag as quickly as possible.
Step 5 - Using a hammer, gently tap the 2" length of CPVC pipe into the PVC coupling in the
bottom of the water feature (FT-120A).
Note: To prevent breakage, do not do this step early.
Step 6 - Place the #5 drain stopper into the hole at the bottom of the bowl on the water feature
(FT-120A).
Step 7 - Drop the support pipes into the holes at the top of the water feature (FT-120A).
7a - Check that the pipes have dropped all the way through the water feature (FT-120A)
AND basin (FT-120C) before going forward.
Step 8 - Insert the stone caps (FT-120CAP) into the holes over the pipes.
Note: The caps are removable.
FT-120A (532 lbs)
55"L x 16"W x 38"H
(2) FT-120CAP (>1 lbs)
1"L x 1"W x 1"H
