CAMPAGNOLO EK13 Manual Download Page 3

Page: 3 / 9

REPLACING THE JOCKEY CAGE - Rev. 01/ 06-2021

CAMPAGNOLO COMPONENTS - TECHNICAL MANUAL

REPLACING THE EKAR JOCKEY CAGE

THIS TECHNICAL MANUAL IS INTENDED FOR USE BY PROFESSIONAL MECHANICS.

Anyone who is not a qualified professional for bicycle assembly must not attempt to install and operate on

the components independently due to the risk of carrying out incorrect operations which could cause the

components to malfunction, resulting in accidents, physical injury or even death.

The actual product may differ from what is illustrated, as the specific purpose of these instructions is to

explain the procedures for using the component.

1.1 - TOOLS REQUIRED

ALLEN WRENCH

TORX WRENCH T15

FIXED WRENCH

8 mm

30 mm

8 mm

T15

Tools supplied by other manufacturers for components similar to Campagnolo

components, may

not be compatible with Campagnolo

components. Likewise, tools supplied by Campagnolo s.r.l.

may not be compatible with components supplied by other manufacturers. Always check with your

mechanic or the tool manufacturer to insure compatibility before using tools supplied by one manu-

facturer on components supplied by another.

1 - DISASSEMBLING THE EKAR REAR DERAILLEUR JOCKEY CAGE

(RD21-EK13)

The operations described in this procedure are only applicable to jockey cage

code RD21-EK13.

Summary of Contents for EK13





