Tank Sold Separately
Read and follow all warnings and instructions in included instruction manual before assembly and use of appliance.
MAX POT DIAMETER 10”
KEEP FOR FUTURE REFERENCE
FOR OUTDOOR USE ONLY
Regulator Model
150/451, R329, RA329, RJ-A
JY70-003, JY95A7A (JY95-007)
RYQ Series (RYQF01)
THIS INSTRUCTION MANUAL CONTAINS IMPORTANT INFORMATION NECESSARY FOR THE PROPER ASSEMBLY AND SAFE USE OF THIS PRODUCT.
Weekender
Model: DJ60LW
• Two 40,000 BTU Cast Aluminum Burners
• Suitcase Style Lid Design
• Detachable Legs
• Convenient Cooking Height
DJ60 INSTRUCTIONS AND TROUBLE SHOOTING
1. Open stove lid, remove, grate and retrieve legs from the inside of the stove.
Reinstall the grate.
2. Turn stove upside down and assemble leg extensions to stove as shown by
inserting the threaded bolt on the legs into the threaded fastener on the corner of
the stove and tightening. (See Fig. 1)
3. Stand stove upright. Open lid. Fold windscreens out and locate the tab on the
windscreens into the cutout on the top edge of the stove. Use the latch to hold
the windscreens in place. (See Fig. 2)
BURNERS WILL NOT IGNITE
1. Make sure there is propane in the tank and turn propane tank is turned on.
2. Follow all instructions in instruction manual for lighting the burner
YELLOW FLAME
1. Adjust Air Shutter until burner has blue flame - Some yellow tipping of the flame
is normal.
2. See Instruction Manual for Cleaning the burner
FLAME IS VERY SMALL AND WON’T INCREASE.
1. Make sure there is propane in the tank and turn propane tank is turned on a
minimum of 3 full turns
2. Follow all instructions in manual for leak testing the stove.
3. Turn all valves on the stove to the off position. Turn the Propane Tank off.
Disconnect regulator from the tank. Reconnect regulator to the tank. Slowly turn
tank on. Follow all instructions in the manual for leak testing the stove. If no
leaks are found follow all instructions in the manual for lighting the appliance.
LATCHES ARE TOO LOOSE TO HOLD LID OR WINDSCREEN TIGHT.
Use a pair of pliers and bend the latch hook slightly to tighten up the fit. Try
latching the lid and windscreen and if either it is still loose try bending the hook a
little more.
