Series 6E electromechanical cylinders
16
EN
Installation of non self-centering locking set
After having adequately positioned the locking set and brought the
motor up to the end stop inside the pin (see picture aside), secure the
screws gradually and uniformly, according to a cross pattern, following
the next steps:
- Manually tighten the screws up to contacting the surface
- Check the position of the hub on the shaft
- Tighten the screws up to half the tightening torque (MS) indicated in
the table
The Series 6E electromechanical cylinder, compliant with standard
ISO 15552, is compatible with the Series 45 anti-rotation guide units.
* for PM-6E-32-0024P length H = 4
** for PM-6E-40-0024P length H = 2
*** or PM-6E-50-0034P length H = 4
SIZE
32
40
50
63
80
100
H [mm]
3 *
3 **
5 ***
5
5
5
PULLEY
CONNECTION
FLANGE
d x D
MS [Nm]
8x18
1,2
10x20
1,2
12x22
1,2
14x26
2,1
15x28
2,1
19x35
4,9
20x38
10
24x47
17
d x D
MS [Nm]
8x11
0,8
14x18
4,8
Installation of self-centering locking set and pulley adjustment
Installation of anti-rotation guide units 45NHT / 45NHB / 45NUT
Position the locking set onto the pulley hub, taking care to keep the
entire locking set within the length of the hub.
Assemble it onto the shaft taking care to maintain the H dimension as
indicated in the table below.
After this, secure the locking set to the shaft with the screws, respecting
the correct tightening torques (MS) indicated in the table.
The application of the Series 45 anti-rotation guide units allows to
withstand possible radial loads. Follow the next steps for their assembly.
STEP 1
Slightly remove the guides (
1
) from the body of the anti-rotation guide
units (
2
) in order to be able to access the fixing screws (
3
) with the tool.
Assemble the body of the anti-rotation guide unit (
2
) on the Series 6E
electromechanical cylinder and fix it with the provided screws (
3
), so that
the lubrication holes are faced upwards.
1
3
2
4
- Repeat this operation up to reaching the indicated tightening torque (MS)
using a torque wrench
- Make sure all screws are tightened at the appropriate tightening torque
(MS) indicated.
N.B. DO NOT USE MOLYBDENUM DISULFIDE BASED LUBRICANTS
