background image

3

Pls take care of a suitable workplace, a garage or hall is better than a place outside. The ambient

temperature during sticking the antenna should lie within a temperature b5˚C to max.+25˚C. If you

work outside avoid direct sunlight!

Always keep to the instructions dealing with chemical products.

Take care of necessary hygienic working conditions.   

Important! 
Pls absolutely keep to each individual point of mounting instruction!

General:

If the surface of the mounting place is made from unknown material, we recommend a "test sticking". If

necessary we can arrange a material analysis at your cost.

Note:

1. Assure that the roof of your vehicle is able to carry the antenna. If you are not sure pls fix a metal plate

(Alu, appr. 2mm thickness) onto the roof. Pls also ask the vehicle's manufacturer.

2. Pls check completeness of parts.

3. Put the antenna on the selected mounting place on the car roof and adjust if necessary.  The mounting

place must be even and no other roof constructions may cover the reception area of the antenna. 

Mark the outline of antenna feet with a suitable pen. 

In case of problems (e.g. the roof is not even but has a curved form instead) pls call our hotline to

arrange further steps.

4. Replace the antenna.

Clean the mounting place and the antenna feet with the supplied special cleaning fluid  "Reiniger1" and

the supplied fleece (pls wear the supplied Latex gloves!).

Grind the marked fixing areas and antenna feet with sandpaper (not too much, the surface must be

rough a little bit only), clean the surface and antenna feet with cleaning fluid 1 again and wait another 10

minutes. 

Attention! Now do not touch the cleaned surface any more!

5. Apply (with the help of the wool wiper-pls wear the supplied Latex gloves!) the Primer 2 evenly and thin

onto the cleaned surface and feet. Then pls wait another 10 minutes. Attention! Do not touch the

cleaned surfaces any more!

Close the Primer 2 bottle at once after use.

screw hole

antenna foot

Preparation:

antenna dome

Summary of Contents for CSA-230M









Reviews: