4. Replace the antenna.
Clean the mounting place and the antenna feet with the supplied special cleaning fluid
"Reiniger1" and the supplied fleece (pls wear the supplied Latex gloves!).
Grind the marked fixing areas and antenna feet with sandpaper (not too much, the
surface must be rough a little bit only), clean the surface and antenna feet with cleaning
fluid 1 again and wait another 10 minutes.
Attention! Now do not touch the cleaned surface any more!
5. Apply (with the help of the wool wiper - pls wear the supplied Latex gloves!) the
Primer 2 evenly and thin onto the cleaned surface and feet. Then pls wait another 10
minutes.
Attention! Do not touch the cleaned surfaces any more!
Close the Primer 2 bottle at once after use.
Note
:
If the surface of the mounting place is made from unknown material, we recommend a
"test sticking". If necessary we can arrange a material analysis at your cost.
Sticking the antenna to your vehicle's roof:
1. Cut the tip of the supplied cartouche special glue "Spezialkleber 3" (pls wear the
supplied Latex gloves!).
2. Apply evenly the glue onto the antenna feet (thickness of glue layer appr. 3 to 4mm
3. Pls put the antenna (max. 5 minutes after applying the glue!) on the selected mounting
place on the car roof. Press the antenna feet smoothly onto the roof and fix the
antenna with tape e.g. to avoid moving. After pressing the antenna feet onto the roof
the minimum thickness of the glue layer must be appr. 2mm.
Now the glue needs a hardening time of appr. 48 hours (air humidity of 50%).
If the air humidity is lower than 50% pls spray some water into the air in the
surrounding of the antenna feet.
4. Remove the outcropped glue on the sides of antenna feet and clean the surface with
the supplied fleece and special cleaning fluid "Reiniger1".
5. In addition you can fix the antenna feet with the help of 4 screws. Pls set the screw
after
hardening of the glue.
antenna foot
antenna dome
screw hole
