19
In an emergency, the door can be opened by hand using a rod or screwdriver at least 15 cm in
length, with a diameter of 2-3mm. Proceed as described below to open the door:
. find the hole under the lower profile of the door;
fig 5.6.1.1
. insert the rod/screwdriver into the hole;
. push up the rod/screwdriver delicately without forcing until you hear the locking mechanism
release.
The door may be opened during a cycle only if the temperature inside the washing
chamber has not exceeded 45°C. Use the keyboard to open the door.
Depending on the settings chosen for the system, a password may be required to
open the door during a washing cycle. However, it is always advisable to wait until the cycle
finishes before opening the door.
It can be potentially dangerous to open the door when the temperature inside the
washing chamber exceeds 70°C due to the escape of steam!
Camlab declines all liability for damage to persons or property caused by forcing the
door open during a wash cycle.
5.7
SECURITY POLICY, USER, SUPER USER & TECH PASSWORDS
For safety reasons, There is a security policy with four password levels that enable or disable
access to the menus of the machine. These are, in increasing order:
.
user level
: For people who actually operate the machine. This password enables access to
“program selection” and “change password” menus only. (This password level may be disabled.)
.
superuser level
: For the person in charge of the machine (supervisor,department head, etc.).
This password can be used to access the following menus:
. PROGRAMMING -> Loading Programs;
. PROGRAM EDITING -> only in relation to volumes of detergent and the drying
parameters;
.
COPY
.
NEW
PROGRAM
. UTILITY -> accesses all the sub-menus (can also change the user passwords)
. WASHING PARAMETERS -> only certain sub-menus, as listed below:
