PM 1000288 000 00
Device handbook SIRAX BT5100
9/32
7. Programming
Programming of transducer can be done in three ways:
1) Programming via Front LCD & two keys.
2) Programming via Programming port available at front of Transducers using optional PRKAB5000 adapter
3) Programming via optional RS485 (Modbus) communication port.
7.1 Programming via Front LCD & Two keys
The following sections comprise step by step procedures for confi guring the SIRAX BT5100 for individual user requirements.
To access the set-UP screens, press and hold the “
DOWN” and “
UP” Key simultaneously for 5 seconds. This will take the User into the
Password Protection Entry Stage (Section 7.1).
Enter Password, prompt for fi rst digit. (*Denotes that digit will be fl ashing).
Pressing the “
Down” key will scroll the value of the fi rst digit from 0 through to 9, the value will wrap
from 9 round to 0.
Pressing the “
Up” key will advance the operation to the next digit and set the fi rst digit.
In the special case where the Password is “0000” pressing the “
Up” key when prompted for the fi rst
digit will advance to the “Password Set/Confi rmed” screen.
Enter Password, fi rst digit entered, prompt for second digit.
(*Denotes that digit will be fl ashing).
Pressing the “
Down” key will scroll the value of the second digit from 0 through to 9, the value will wrap
from 9 round to 0.
Pressing the “
Up” key will advance the operation to the next digit and set the second digit.
Enter Password, second digit entered, prompt for third digit.
(*Denotes that digit will be fl ashing).
Pressing the “
Down” key will scroll the value of the third digit from 0 through to 9, the value will wrap
from 9 round to 0.
Pressing the “
Up” key will advance the operation to the next digit and set the third digit.
Enter Password, third digit entered, prompt for fourth digit.
(*Denotes that digit will be fl ashing).
Pressing the “
Down” key will scroll the value of the fourth digit from 0 through to 9, the value will wrap
from 9 round to 0.
Pressing the “
Up” key will advance the operation to the “Password Set/Confi rmed” and set the fourth
digit.
7.1.1. Password Protection
7.1.1.1 Password Verifi cation
Password protection can be enabled to prevent unauthorised access to set-up screens, by default password protection is not enabled.
Password protection is enabled by selecting a four digit number other than 0000, setting a password of 0000 disables the password protection.
ON
O/P1
O/P2
COM
ON
O/P1
O/P2
COM
ON
O/P1
O/P2
COM
ON
O/P1
O/P2
COM
*
*
*
*
