Cameo LED DROPIX 66, User Manual

Page: 14 / 160

SLAVE MODE
Press the MODE button several times if necessary to enter the the upper menu
of the display. Now use the UP and DOWN buttons to select the Slave Mode
and confirm by pressing the
ENTER button.
Once the slave unit has been connected to the master unit (same model) using
a DMX cable (Master = DMX OUT, Slave = DMX IN), and the master unit has
been set to one of the standalone modes (automatic control or music control),
the slave unit follows the master unit.
SETTING THE DMX START ADRESS
Press the MODE button several times if necessary to enter the the upper menu
of the display. Now use the UP and DOWN buttons to select the DMX Address
and confirm by pressing the
ENTER button.
The display now shows
DMX MODE Addr:xxx
and one of the 3 available DMX
modes (3CH, 5CH, 8CH). Press the UP and DOWN buttons to select the desired
DMX start address (Addr:001 - Addr:512). Confirm the input with ENTER.
DMX mode (DMX CH mode)
Press the MODE button several times if necessary to enter the the upper menu
of the display. Now use the UP and DOWN buttons to select the DMX CH Mode
and confirm by pressing the ENTER button.
The display now shows DMX CH Mode and one of the 3 available DMX modes
(3CH Mode, 5CH Mode, 8CH Mode) . The DMX mode can be adjusted as
desired by using the UP and DOWN buttons. Confirm the input with ENTER.
SOFTWARE VERSION
The software version of the DROPIX controller can be obtained by pressing the
MODE button (possibly several times) in the top menu level, then using the UP
and DOWN buttons, select the menu item Software Version . After you have
confirmed with ENTER, the software version is displayed as the firmware
version number.
NOTE:
The illumination of the LC display switches off automatically after approx. 30
seconds of inactivity. Pressing any one of the 4 control buttons will turn the
illumination of the LC display on again.
OPERATION
:
14 15
ENGLISH
DEUTSCH
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
ESP
AÑOL
POLSKI
IT
ALIANO