Cameo CLP56Q8W, User Manual

Page: 12 / 148

12 13
ENGLISH
DEUTSCH
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
ESP
AÑOL
POLSKI
IT
ALIANO
COLOUR BLENDING
In the colour fade mode (Fading Mode) different colours are blended into one
another in succession. The speed of the program is adjustable separately and a
stroboscope effect can also be activated.
Press the MODE button repeatedly until "FXXX" appears in the display.
To adjust the speed of the colour fade, press ENTER (the 2nd digit on the display
flashes) and then use the UP and DOWN buttons to select the desired speed in
the "FAXX" menu. Now, press ENTER again (the last two digits on the display
will flash) and using the UP and DOWN buttons, select the speed with which the
colours fade, from FA00 to FA99. Confirm with ENTER.
To activate and adjust the strobe effect, press ENTER (the 2nd digit on the display
flashes) and then use the UP and DOWN buttons to select the desired strobe effect
in the "FFXX" menu. Now, press ENTER again (the last two digits on the display
will flash) and using the UP and DOWN buttons, select the strobe speed from FF00
to FF99 (FF00 = strobe effect deactivated, approx. 1 Hz = FF01, FF99 = approx.
20 Hz). Confirm with ENTER.
Colour fading Speed FA00 - FA99
Stroboscope Speed FF00 - FF99
AUTO MODE
Press the MODE button repeatedly until "AUTO" appears on the display. In this
operating mode, the light switches automatically between colour change and
colour fading mode. The speed of the individual effects is determined by the
settings of the respective mode.
SLAVE MODE
Press the MODE button repeatedly until "SLAV" appears on the display. Connect
the slave and master unit of the same type with a DMX cable (master unit DMX
OUT - slave unit DMX IN). Now the slave unit follows the master unit.
MUSIC CONTROL
Press the MODE button repeatedly until "SUXX" appears on the display.
Now the projector is controlled by the built-in microphone and follows the beat
of the music. To adjust the microphone sensitivity, press ENTER (the last two
digits on the display will flash) and use the UP and DOWN buttons to set the
desired value from SU00 to SU99 (SU00 = minimum sensitivity, SU99 = maximum
sensitivity). Confirm with ENTER.
OPERATION
: