6
7
M
N
L
N
+ 10
- 11
10
E
1
2
2
C1
2
7
+ E -
10 11 E 1 2 7 C1
M N
L N
T.C.A.
ZL56
SENS.
FUS. MOTORE 7.5A
2
1
ON
FUS.
A
CC.
3,15A
FUS. CENTR.
315mA
APRE
AP / CH
AF
26V17V 0V
M N
+ E -
ENC/RADIO
T.C.A.
ZL56
SENS.
FUS. MOTORE 7.5A
2
1
ON
FUS.
A
CC.
3,15A
FUS. CENTR.
315mA
APRE
AP / CH
AF
26V17V 0V
M N
+ E -
ENC/RADIO
T.C.A.
ZL56
SENS.
FUS. MOTORE 7.5A
2
1
ON
FUS.
A
CC.
3,15A
FUS. CENTR.
315mA
APRE
AP / CH
AF
26V17V 0V
M N
+ E -
ENC/RADIO
T.C.A.
120"
1"
SENS.
max.
min.
2
1
ON
Red led
Green led
230V (a.c.) power supply
24 (d.c.) motor
Powering accessories (max 40W)
- 24V (A.C.) with power supply at 230V (A.C.)
- 24V (D.C.) with power supply at 24V (A.C.)
24V output in motion (e.g. 25 W max. flashing light)
Pushbutton stop (N.C.)
Contact (N.C.) for «re-aperture during closure»
Pushbutton for commands (N.O.) “OPEN-STOP-CLOSE-STOP”
Antenna connection
ELECTRICAL CONNECTIONS
N.B.
All the contacts and push-buttons
normally closed (N.C.) that are not used
must be short-circuited.
Trimmer T.C.A.
= Automatic closing time adjustment. N.B.:
by adjusting the minimum, the automatic closure function
is excluded.
Trimmer SENS.
= Amperometric sensitivity adjustment.
1 ON
- Encoder programming; it enables the procedure for
the calibration of the opening and closing end-stop.
2
Not used, keep the dip in position OFF.
RED LED:
- light on, memorizing of the limit-switch (encoder);
- slow intermittent light, memorizing of the radio board and
automatic-closing count;
- rapid intermittent light, signals the presence of an obstacle
or an anomaly on the device connected to contacts 2-C1.
GREEN LED:
- constant light, signals the power supply in the control
board (goes off when power not supplied and each time the
total stop button is pressed).
ADJUSTMENTS
FUNCTIONS CONTROL LED
SELECTION OF FUNCTIONS
