FA01695M4A - 06/2022
FA01695M4A - 06/2022
Connection to the control panels.
⚠
Always connect the LAMP terminal to the W-E1 terminals on the
230 V panels
⑪
or the 10-E input of the RIOCT8WS to terminals
10-E or 10-E1 of the 24 V control panels
⑫
.
☞
Always enable the pre-fl ashing.
☞
Enable the services test (if present).
☞
Generally avoid those conditions in which when the operator is idle
the fl ashing light is active.
For example, with function C4 enabled on the CAME panel, if the
photocell is engaged, the RIO accessories shall remain active for the
entire intervention period, thus reducing battery life.
RESETTING procedure
Keep the RESET button pressed for 10 seconds, until the WIRELESS LEDs
start fl ashing.
N.B.: If you replace any device on the system, you will have to
RESET and then again SAVE all of the system devices.
Functional checks
Issue a start command (each RIO accessory will fl ash * blue)
Make sure that the RIOLX8WS activates.
Obstruct the gate's action and check whether the RIOPH8WS and/or
RIOED8WS devices actually activate the prescribed safety function.
When the maneuver is complete, each RIO accessory will fl ash* red and
switch into LOW POWER mode to preserve the batteries.
⚠
In LOW POWER mode, the photocells will respond more slowly - the
LED fl ashes blue - to the manual operation test.
* If this does not happen, cut off the mains power supply and increase
the radio signal's range/power by setting the jumper
⑤
to position H.
Troubleshooting
Alerts
Possible causes
Fix
WIRELESS
CH1
CH2
TS terminal (safety test)
not connected.
Connect the TS terminal
(or 2, is missing) to the
corresponding one on the
control panel.
WIRELESS
CH1
CH2
No Rio accessory is
memorized.
Confi gure RIO
accessories.
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
The photocells:
a. detect an
obstruction;
b. are misaligned;
c. have fl at batteries.
a. Remove the
obstruction.
b. Align the photocells.
c. Replace the batteries.
WIRELESS
CH1
CH2
WIRELESS
CH1
CH2
The sensitive
safety-edge does not
intervene.
Check settings and
adjustments on the
sensitive safety-edge.
LED stays on,
LED is off ,
LED fl ashes
Buzzer active
