CAME LVC/01, Programming Manual, Page: 10 / 16

1
1
1
J J
8 8
I I
1 P.E
1 P.E
1 P.E
2 P.E
2 P.E
2 P.E
beep beep
M
PROG PROG
K K
<1’’
Page
10
- Manual
FA01031-IT
- 08/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Page
10
- Manual
FA01725-EN
- 03/2022 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Press one of the call keys on the entry panels to be reprogrammed, the LEDs
backlighting the call keys
8 will stop fl ashing. Repeat this operation on all the
entry panels to be reprogrammed 8 and 9 .
If all the entry panels are reprogrammed, the confi guration will be as shown
in fi gure
J .
To exit reprogramming, briefl y press the PROG key on the power supply K : the
PROG LEDs and the LEDs backlighting the keys will go out.
If no action is performed, the procedure will end automatically after 30 minutes.
If an entry panel is added, replaced or removed, the modifi cations
are acquired by going into "Programming Type of Keys" (from fi gure
6
to
K
).
AUTOMATIC DOOR RELEASE function
For internal receivers that support the AUTOMATIC DOOR RELEASE function only.
This function is used to open the entrance automatically when there is a call from the entry panel. No communication is
activated and the call ends automatically.
☞
Follow the instructions in the internal receiver manual.