CAME FA7024CB, Installation Manual, Page: 57 / 128

ESC < > ENTER
ESC < > ENTER
ESC < > ENTER
ESC < > ENTER
ESC < > ENTER ESC < > ENTER
ESC < > ENTER
M2
M1
A
B
B
C
D
D
O
D
B
A
C
B
D
O M O N
E
G
F H
I L
Page
25
- Manual
FA01047-EN
- 08/2018 - © C
AME S.p.A. - Original instructions
SAVING AND UPLOADING DATA USING THE MEMORY ROLL
For saving user and system configuration data with the Memory Roll, and for then reusing them on another control board, even on
fitted into another system.
Caution! Fitting and extracting the Memory Roll must be done with the mains power disconnected.
❶
Fit the Memory Roll into the its corresponding connector on the control board.
❷
Select
F50
. Press ENTER to confirm.
❸
Select
ON
. Press ENTER to confirm the data saving procedure.
❹
Extract the Memory roll and fit it into the connector of another control board.
❺
Select F51. Press ENTER to confirm.
❻
Select
ON
. Press ENTER to confirm the data uploading procedure.
SLOW-DOWN POINTS AND END-STROKE AREAS
A = Movement area at normal speed.
B* = Movement area at slowed-down speed.
C = Encoder intervention zone with movement inversion.
D = Encoder intervention zone with movement stopped.
E = Opening slow-down starting point for M1.
F = Closing slow-down starting point for M1.
G = Opening slow-down starting point for M2.
H = Closing slow-down starting point for M2.
I** = Closing approach starting point for M1.
L** = Closing approach starting point for M2. M** = Opening slow-down starting point for M1.
N** = Opening approach starting point for M2.
O = Strike plates..
* Minimum 600 mm from the strike plate.
** Set the closing-rest percentage for function F 39 - F 40 for the first
motor (M1) and F43 - F44 for the second motor (M2) so as to achieve a
distance of less than 50 mm from the strike plate.