Pa
g
e
5
- M
an
u
al
c
od
e:
11
9
G
3
7
8
4
E
N
11
9
G
3
7
8
4
E
N
ve
r.
2
2
0
2
/2
0
14 © C
A
M
E
c
an
ce
lli
auto
m
ati
ci
S
.p.
A
. - T
h
e d
ata a
n
d i
n
fo
rm
ati
on p
rovi
d
ed
in
th
is
m
an
u
al
a
re s
u
b
je
ct to c
h
an
g
e at a
ny ti
m
e w
ith
ou
t p
ri
or n
oti
ce
by C
A
M
E
C
an
ce
lli
A
u
to
m
ati
ci
S
.p.a.
Examples of use
Standard installation
Wall flanking installation
Multiple installation
(mm)
⚠
The output managed by a turnstile should not be considered an emergency exit! Always provide an exit for emergency situations and for the physically impaired.
Recommended distance.
Preliminary checks
PSAP08
PSAP08
PSAP07N
PSAP07N
Tools and materials
⚠
The following is necessary before installing the turnstile:
• If necessary provide for the corrugated tubing to route electrical cables;
• Provide a suitable single-pole disconnector with a maximum of 3 mm between the contacts, to disconnect the power supply;
• Prepare piping and ducts suitable for routing the electrical cables, ensuring protection against mechanical damage;
•
make sure that any connections within the container (made to ensure the continuity of the protection circuit) are fitted with additional insulation compared to
the other internal conductor parts.
Types of cables and minimum thicknesses
PSAP08
PSAP08
PSAP07N
PSAP07N
☞
If the cables differ in length compared to what is shown in the table, the cable cross-section is determined according to the actual current draw of the devices
connected and according to the provisions of the IEC EN 60204-1 standard.
For connections that require several, sequential loads, the sizes given on the table must be re-evaluated based on actual power draw and effective distances. When
connecting products that are not specified in this manual, please refer to the documentation provided with said products.
Connection
Cable type
Cable length
1 < 10 m
Cable length
10 < 20 m
Cable length
20 < 30 m
Control panel power supply 120/230 V
FROR CEI 20-22
IEC EN
50267-2-1
3G x 1.5 mm
2
3G x 1.5 mm
2
3G x 1.5 mm
2
Accessory power supply
2 x 0.5 mm
2
2 x 0.5 mm
2
2 x 1 mm
2
Control and safety devices
2 x 0.5 mm
2
2 x 0.5 mm
2
2 x 0.5 mm
2
Make sure you have all the tools and materials you will need for the installation at hand to
work in total safety and compliance with current standards and regulations. The figure shows
some examples of installer’s tools.
INSTALLATION
The following illustrations are only examples, given that the space for securing the turnstile and accessories varies depending on the overall dimensions. The
installation technician is responsible for choosing the most suitable solution.
⚠
The turnstile must be mounted by two people. Transport and lift using appropriate lifting equipment.
⚠
Risk of tipping over! Do not lean on the turnstile until it is fully secured.
GENERAL INSTRUCTIONS FOR INSTALLATION
⚠
Installation must be carried out by qualified and experienced personnel in compliance with applicable regulations.
