CAME BPT DC/01, Programming Manual, Page: 11 / 16

5),'
352*
²
0
352*
1
2
beep beep beep beep
3 4
12345 12345
+ +
5
beep beep
>10’’ >10’’
>1’’ >1’’
beep beep
beep beep
6
7
12345 12345 12345 12345
beep beep beep beep
+ +
8 9
352*
5),'
352*
²
J
P
age
11
- Manual
FA01031-IT
- 08/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
P
age
11
- Manual
FB00865-EN
- 11/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
P
age
11
- Manual
FB00865-EN
- 11/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Original instructio
ns
Badge. Bring a badge/tag up to the reader of any entry panel that
has already been addressed 3 and, after the confi rmation beep,
repeat this once again to confi rm
4
: ALL the badges relating to
the GROUP will be deleted.
Codes. Press , enter the access code (4-8 fi gures) followed by the key on the key-
pad of any entry panel that has already been addressed 5 and, after the confi rmation
beep, repeat this once again to confi rm: ALL the codes relating to the GROUP will be
deleted.
Badges and Codes. Entry panels with buttons: hold down for at least 10 seconds the
call key
6
relating to the GROUP for which the codes are to be deleted and, after the
beep, press the key again (briefl y) 7 . In this way ALL the GROUP's codes and badges
of any type will be deleted.
Entry panels with DNA. Enter the call code followed by the
8
key related to the
GROUP for which the codes are to be deleted and, after the beep, enter the call code
again followed by the key
9
. In this way ALL the GROUP's codes of any type will
be deleted.
Finally, reposition the PROG RFID jumper in the rest position J : the procedure is
NOT terminated automatically!
Deleting Codes and Tags
Position the power supply's PROG RFID jumper at “–”
1
: the power supply's PROG LED
will fl ash slowly, along with the message LEDs with the confi guration in fi g. 2 . If the
LEDs immediately go out it means there is a malfunction in the connections between the
power supply and the entry panel. Check the connections and return to programming.