p.
11
F
B0
06
80-
EN
F
A0
08
11
-E
N v.
1
- 1
1/
20
17 - © C
AM
E S
.p
.A
. - T
he c
on
te
nt
s o
f t
hi
s m
an
ua
l m
ay b
e c
ha
ng
ed
, a
t a
ny t
im
e, a
nd w
ith
ou
t n
ot
ic
e.
Do not touch the temperature sensor, to prevent it from misreading the detected value.
To clean this device only use a soft, water-moistened cloth.
- This icon appearing on the display means that the keypad is locked by the terminal and
that no operations can be done locally.
- The module can control the zone's temperature even if a control terminal is malfunctioning
or missing.
Identifying the device on home-automation systems
On the back of the device, there is a tag bearing the alphanumerical code that identifies the
device (serial number "SN") within a home-automation system.
To send the serial number or SN to the programming software over the home-automation
bus, press these buttons
simultaneously for at least two seconds; the front LED turns
on for one second to confirm that the serial number has been transmitted.
Note: When the front LED is always on, it means the device is malfunctioning.
Local settings allowed on the zone thermostat
The TA/P1 zone thermostat works according to the settings that have been programmed via
the interface of the home-automation system of which it is a part; the only local operation
allowed is the variation of the zone module's operating mode, by pressing this button
.
Automatic operation
The module control the temperature, according to the temperature profile set via the home-
automation system's interface.
Manual operation
By pressing these
buttons you can change - by ±2 °C - the value set by the home-
automation system's interface; the set temperature will remain steady until it is programmed
otherwise or the mode is changed.
Scheduled manual operation
By pressing these buttons
you can establish for how long the temperature, which is set
for manual operation, must be maintained.
After about three seconds from the latest operation, the room-temperature reading will appear.
Jolly
The module controls the temperature according to the temperature profile set via the home-
automation system's interface of the Jolly program.
After about three seconds from the latest operation, the room-temperature reading will appear.
