Cambridge Sensotec Rapidox 1100E Oxygen Analyser Instruction Manual
Version 3.8
18
Last printed 29/08/2012 16:01:00
Figure 6: Rapidox configuration page. Values shown are examples only
The yellow ‘Status’ box at the bottom will display confirmation that the Rapidox
was found and the result of the last action, or any error messages if there is a
problem with communication. If you experience problems check that your serial
cable (supplied) is correctly fitted to a valid serial port. There are several types of
serial cable available. You must use a cable as supplied where there are straight
through connections, i.e., pin 2 to pin 2, pin 3 to pin 3 and pin 5 to pin 5. Other
cable formats will not work. Also check the status of your COM port settings in
Device Manager accessed by clicking START – Settings - Control Panel. If your PC
does not have a serial port, you can use a USB to RS232 adapter – please contact
Cambridge Sensotec if you would like advice about selecting one.
7.3
On-Screen Help
You can access the on-screen help facility at any time by clicking on the help
menu on the menu bar and select the ‘Help’ option or press F1.
7.4
Configuration Page
The configuration page is split into three, and you can switch between them by
clicking on the tabs labelled ‘Config 1’, ‘Config 2’ or ‘Alarm Config’. Each page
allows the user to reprogramme an array of parameters used by the Rapidox. Once
written to the Rapidox, the new parameters remain permanent until overwritten.
Summary of Contents for SENSOTEC Rapidox 1100E
Page 46: ......
