12
Volume ramp
Mode
Volume
Display
Sub LPF
Vol Ramp
PP Mute
Settings
Power
Control
The 851E automatically ramps the volume down when going into
Standby mode and up when coming out of Standby mode. To turn this
feature off, press the Vol Ramp input select button in the System settings
menu and set to off. Press the Mode button to exit the System settings
menu.
Volume display
Mode
Volume
Enable
Vol dB
Display
Bright
To change the volume display from decibels (-90 to 0dB) to arbitrary
volume units (0 to 90 units) select the Vol dB input button in the Display
submenu to turn off the volume in decibels. Press the Mode button to
exit the submenu.
Pre-amplifier setup continued
Surround sound source e.g. 752BD player
Stereo source e.g. 851C CD player
AV receiver
e.g. 651R
851W
851E
L
R
SL
SR
C
SW
Example
851E/W used with an AV receiver
connected to Input 7 (which is then
set to fixed gain mode).
5.1 speaker connections shown.
Volume trim
Note: The Volume Trim menu item is hidden if the Fixed Volume is
enabled.
The relative levels of the inputs can be adjusted by gain trim. This allows
each to be adjusted so that each sounds the same in terms of average
loudness when you switch between them. Pick the loudest sounding
source and trim its level until it matches the average perceived level of
the others. Repeat this process if other sources also stand out as louder
than the average.
To set the input gain trim for each source, press and hold the required
input source button then select Vol Trim in the submenu:
Mode
Volume
Enable
Apply
Save
Vol Trim
Minimum
Maximum
Current
Press the Enable button and use the volume control to set the gain
between 0 and -12 dB (the available range is restricted if the volume
is set very low). Press the Apply button to temporarily hear the new gain
settings, re-adjust the gain if necessary and press the Apply button
again. Press the Save button to save and exit the submenu.
Pressing the Current button will display the current volume value. This
is a useful function when setting new gain value and comparing it to the
current volume.
The other two settings sets the gain as following:
Minimum
– Sets the minimum gain value to -1dB.
Maximum
– Sets the maximum gain value to -12dB.
