MMX 32 VGA MTP • Installation and Operation
MMX 32 VGA MTP • Installation and Operation
Installation and Operation, cont’d
2-5
Rear Panel Features and Cabling
INPUT 2
INPUT 1
AUDIO
AUDIO
OUTPUT 1
L
R
AUDIO
INPUT 3
AUDIO
AUDIO
POWER
12V
0.5A MAX
REMOTE
RS-232
+5V
2
1
1 2 3
Tx Rx
SYNC - TRI
PRE PEAK - ON
OUTPUT 2
RGB/AUDIO
CONT
A
C
T
9
1
2
3
4
6
5
7
8
BI
OFF
Figure 2-4 — MMX 32 VGA MTP rear panel
Inputs
1
Video and audio inputs —
Connect computer video sources to
these female 15-pin HD connectors. Connect audio sources to
these 3.5 mm stereo jacks. Wire the audio connectors as shown
in figure 2-5.
S
leeve ( )
Ring (R)
Tip (L)
3.5 mm Stereo Plug Connector
(unbalanced)
Outputs
2
Video output 1 —
Connect an output monitor or other VGA
device to this female 15-pin HD connector.
3
Audio output 1 —
Connect speakers to this 3.5 mm stereo jack.
4
Audio/Video (RGB) output 2 —
Connect an MTP R 15 HD A or
MTP RL 15HD A receiver to this RJ-45 UTP connector.
See TP Cable Termination on page 2-9 to properly wire the RJ-45
connectors.
Then connect a projector or other RGB video output device to
the receiver, and connect speakers for summed mono audio
(L and R).
2-4
Furniture mounting
For furniture mounting (under a desk-top or shelf), do not
attach the rubber feet.
Furniture mount the switcher using the optional mounting kit
(part #70-077-01) as illustrated below.
Figure 2-3 — Mounting the MMX 32 VGA MTP
under furniture
Drill pilot holes 1/4" (6.4 mm) deep and 3/32" (2 mm) in
diameter in the table or desk at the marked screw locations.
The holes should be drilled from the underside or inside
(concealed side) of the furniture, where the switcher will be
located.
Figure 2-5 — Audio input connection
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
