Chapter 20: Ethernet Protocols (CLI)
Configuring LLDP (CLI)
phn-3965_006v002
Page 20-27
root> ethernet mstp show-port-counters interface <interface> slot <slot>
port <port>
To view the BPDU counters for an interface group, enter the following command in root view:
root> ethernet mstp show-port-counters group <group>
To reset the BPDU counters, enter the following command in root view:
root> ethernet mstp reset-counters
Table 274
Port BPDU Counters CLI Parameters
Parameter
Input Type
Permitted Values
Description
interface
Variable
eth
radio
pwe
Enter the type of interface:
eth
–
Ethernet
radio
–
Radio
pwe
–
TDM
slot
Number
1
port
Number
ethernet: 1-6
radio: 1-2
management: 1-2
tdm: 1
The interface for which you want to display
counters.
group
Variable
rp1
rp2
rp3
rp4
lag1
lag2
lag3
lag4
mc-abc1
mc-abc2
mc-abc3
mc-abc4
To display counters for a LAG group, or a
Multi-Carrier ABC group, use this parameter
instead of the interface, slot, and port
parameters to identify the group. See:
•
Configuring HSB Radio Protection (CLI)
•
Configuring Link Aggregation (LAG) and
LACP
•
Configuring Multi-Carrier ABC (CLI)
Configuring LLDP (CLI)
Link Layer Discovery Protocol (LLDP) is a vendor-neutral layer 2 protocol that can be used by a network element
attached to a specific LAN segment to advertise its identity and capabilities and to receive identity and capacity
information from physically adjacent layer 2 peers. LLDP is a part of the IEEE 802.1AB
–
2005 standard that enables
automatic network connectivity discovery by means of a port identity information exchange between each port
and its peer. Each port periodically sends and also expects to receive frames called Link Layer Discovery Protocol
Data Units (LLDPDU). LLDPDUs contain information in TLV format about port identity, such as MAC address and IP
address.
Summary of Contents for PTP 820 Series
