Chapter 14: Getting Started (CLI)
Configuring the Radio (MRMC) Script(s) (CLI)
phn-3965_006v002
Page 14-31
Assigning an MRMC Script to a Radio Carrier (CLI)
Once you have a list of valid scripts, you can assign a script to the radio carrier. The command syntax differs
depending on whether you are assigning a script with ACM support or a script without ACM support.
Note
When you enter a command to change the script, a prompt appears informing you that changing the
script will reset the unit and affect traffic. To continue, enter
yes
. Changing the maximum or
minimum profile does not reset the radio interface.
To assign a script with ACM enabled, go to radio view and enter the following command:
radio[x/x]> mrmc set acm-support script-id <script-id> modulation
adaptive max-profile <profile>
To assign a script without ACM enabled, go to radio view and enter the following command:
radio[x/x]> mrmc set acm-support script-id <script-id> modulation fixed
profile <profile>
To display the current MRMC script configuration, go to radio view and enter the following command:
radio[x/x]>mrmc show script-configuration
Table 137
MRMC Script Assignation to Radio Carrier CLI Parameters
Parameter
Input Type
Permitted Values
Description
script-id
Number
Depends on
available scripts.
The ID of the script you want to assign to the
radio carrier.
modulation
Variable
adaptive
fixed
Determines whether ACM is enabled (adaptive)
or disabled (fixed).
max-profile
Number
For fixed interfaces
and RMC-B: 0
–
10
For RMC-A: 0
–
7
Adaptive ACM mode only: The maximum profile
for the script. For example, if you select a
maximum profile of 5, the system will not climb
above profile 5, even if channel fading
conditions allow it.
min-profile
Number
For fixed interfaces
and RMC-B: 0
–
10
For RMC-A: 0
–
7
Adaptive ACM mode only: The minimum profile
for the script. For example, if you select a
minimum profile of 3, the system will not go
below profile 3 regardless of the channel fading
conditions. The minimum profile cannot be
greater than the maximum profile, but it can be
equal to it.
If you do not include this parameter in the
command, the minimum profile is set at the
default value of 0.
Summary of Contents for PTP 820 Series
