Chapter 9: TDM Services and Interfaces
Configuring Native TDM Trails
phn-3965_006v002
Page 9-19
14
To create the trail with the displayed parameters, click
Submit
. If you want to return to an earlier page and
change the trail parameters, click
Back
.
Note
An invalid configuration error may occur in the event that another user utilized a resource that you
selected, such as an interface or a Trail ID, between the time you selected the resource and the time
you pressed
Submit
. If this occurs, you must go back and, if necessary, select alternative resources
for the trail.
Adding a Trail between Radio Ports, Radio Groups, or Cascading
Interfaces
Note:
In order to add a radio, radio group, or cascading interface as a trail endpoint, an MNG service point must
be added to the interface or group in the pre-defined management service (Service ID 1025) or in a Pipe service.
See
1
In the Interface #1 screen of the TDM Services Creation page, configure the parameters of the trail's first
endpoint.
Summary of Contents for PTP 820 Series
