Chapter 8: Ethernet Protocols
Configuring G.8032
phn-3965_006v002
Page 8-12
Initiating a Manual or Forced Switch and Clearing the Switch
or Initiating Reversion
You can initiate a manual or forced switch, clear the switch, and initiate reversion, from the G.8032 ERPI Attribute
–
State page:
1
Select
Ethernet > Protocols > G.8032 > ERPI Attribute
. The G.8032 ERPI Attribute page opens (
2
Select the ERPI and click
State
. The ERPI Attribute
–
State page opens (
3
Select the service point on which you want to perform the operation.
o
To initiate a forced switch, click
Force Switch
.
o
To initiate a manual switch, click
Manual Switch
.
o
To clear a forced or manual switch, click
Clear
. You can also click
Clear
to trigger convergence prior to the
expiration of the relevant timer.
Blocking or Unblocking R-APS Messages on a Service Point
To enable or disable transmission of R-APS messages on a service point:
1
Select
Ethernet > Protocols > G.8032 > ERPI Attribute
. The G.8032 ERPI Attribute page opens (
2
Select the ERPI and click
State
. The ERPI Attribute
–
State page opens (
3
Select the service point on which you want to perform the operation.
o
To block R-APS message transmission on the service point, click
R-APS Block
.
o
To enable R-APS message transmission on the service point, click
R-APS Unblock
.
Viewing ERPI Statistics
To view statistics about an ERPI:
1
Select
Ethernet > Protocols > G.8032 > ERPI Attribute
. The G.8032 ERPI Attribute page opens (
2
Select the ERPI and click
Statistics
. The ERPI Attribute
–
Statistics page opens.
Figure 261
G.8032 ERPI Attribute
–
Statistics Page
lists and describes the statistics shown in the ERPI Attribute
–
Statistics page.
Summary of Contents for PTP 820 Series
