Chapter 5: Radio Configuration
Configuring and Viewing Radio PMs and Statistics
phn-3965_006v002
Page 5-44
Displaying PMs for the Combined IF Combining Signal
Note
This section is only relevant for PTP 820G.
Related Topics:
•
Displaying PMs for the Combined IF Combining Signal
IF Combining is a space diversity configuration in which the RFU receives and processes two signals and combines
them into a single, optimized signal. You can display RSL (Received Signal Level) PMs for the combined signal, as
well as for the Diversity interface.
Note:
RSL PMs for the Main interface are displayed in the standard RSL fields of the Signal Level PM report page.
Displaying Signal Level PMs and Configuring Signal Level PM Thresholds
To display combined RSL PMs per radio:
1.
Select
Radio > PM & Statistics > Combined
. The Combined PM graph page opens.
Figure 178
Combined PM Graph Page
2.
In the
Interface
field, select the radio interface for which you want to display PMs.
3.
In the
Interval Type
field:
•
To display reports in 15-minute intervals, select 15 minutes.
•
To display reports in daily intervals, select 24 hours.
describes the Combined PMs.
Summary of Contents for PTP 820 Series
