Chapter 24: Alarm Management and Troubleshooting (CLI)
Performing Diagnostics (CLI)
phn-3965_006v002
Page 24-14
The following commands initiate an IF loopback on radio interface 2, with a timeout of two minutes:
radio[2/1]> radio loopbacks-timeout set duration 2
radio[2/1]>rf loopback-rf set admin on
Performing Ethernet Loopback (CLI)
Ethernet loopbacks can be performed on any logical Ethernet interface except a LAG. When Ethernet loopback is
enabled on an interface, the system loops back all packets ingressing the interface. This enables loopbacks to be
performed over the link from other points in the network.
To configure loopback on an Ethernet interface, go to interface view for the interface and enter the following
command:
eth type eth[x/x]> loopback admin <loopback-admin-state>
To configure the loopback duration time, go to interface view for the interface and enter the following command:
eth type eth[x/x]> loopback set duration <loopback-duration>
You can select whether to swap DA and SA MAC addresses during the loopback. Swapping addresses prevents
Ethernet loops from occurring. It is recommended to enable MAC address swapping if LLDP is enabled.
To configure MAC address swapping, go to interface view for the interface and enter the following command:
eth type eth[x/x]> loopback swap-mac-address admin <MAC_swap-admin-state>
To view loopback status, go to interface view for the interface and enter the following command:
eth type eth[x/x]> loopback status show
Table 322
Ethernet Loopback CLI Parameters
Parameter
Input Type
Permitted Values
Description
loopback-
admin-state
Variable
enable
disable
Enter
enable
to enable Ethernet
loopback on the interface, or
disable
to
disable Ethernet loopback on the
interface.
loopback-
duration
Number
1 - 900
The loopback duration time, in seconds.
MAC_swap-
admin-state
Variable
enable
disable
Enter
enable
to enable MAC address
swapping, or
disable
to disable MAC
address swapping.
The following command enables Ethernet loopback on Ethernet interface 2.
eth type eth [1/2]> loopback admin enable
The following command sets the loopback duration time to 900 seconds.
eth type eth [1/2]> loopback set duration 900
The following command enables MAC address swapping during the loopback.
eth type eth [1/2]> loopback swap-mac-address admin enable
Summary of Contents for PTP 820 Series
