Chapter 23: Access Management and Security (CLI)
Configuring X.509 CSR Certificates and HTTPS (CLI)
phn-3965_006v002
Page 23-18
Enabling HTTPS (CLI)
By default, HTTP is used by PTP 820G and PTP 820F as its web interface protocol.
To change the protocol to HTTPS, enter the following command in root view:
root> platform security url-protocol-set url-protocol https
Note
Make sure you have installed a valid certificate in the PTP 820G or PTP 820F before changing the web
interface protocol to HTTPS. Failure to do this may prevent users from accessing the Web EMS.
To change the protocol back to HTTP, enter the following command in root view:
root> platform security url-protocol-set url-protocol http
To display which protocol is currently enabled, enter the following command in root view:
root> platform security url-protocol-show
Summary of Contents for PTP 820 Series
