Cambium Networks PTP 820 Series, Installation Manual

Page: 55 / 179

Installation Guide for RFU-D-HP
Page 55 of 179
Connecting a CAT-5e/CAT-6 Data Cable
If you need to assemble the CAT-5e or CAT-6 cable, follow the instructions in section 0, Preparing the CAT-5e or CAT-6
Cable and Plug-in Field, then proceed to section 0, Connection of CAT-5e or CAT-6 Cable to RFU-D-HP.
If you using a pre-assembled CAT-5e or CAT-6 cable, follow the instructions in section 0, Preparing the CAT-5e or CAT-6
Data Cable Already Assembled, then proceed to section 0, Connection of CAT-5e or CAT-6 Cable to RFU-D-HP.
Note: To ensure proper grounding and connectivity, it is recommended to use pre-
assembled CAT-5e or CAT-6 cables.
Preparing the CAT-5e or CAT-6 Cable and Plug-in Field
Important Note! To ensure proper grounding, the RJ-45 plug must be shielded, with a crimping
tail.
Table 17: Materials for Preparing Ethernet Data Cables
P/N Description
N000082L016A PTP 820 CAT5E Outdoor 100m drum
N000082L172A PTP 820 CAT6A Outdoor Cable 305m drum
N000082L014A PTP 820 Glands_x5_KIT
N000082L173A PTP 820 High Speed GND Kit for CAT6A Cable
N000082L073A PTP 820 GBE_Connector_kit
To prepare the CAT-5e or CAT-6 cable and plug-in field:
1 Prepare the gland and insert the cable, as described in General Installation Procedure on page 43.
2 Strip off approximately 45 mm of the outer insulation jacket from the CAT-5e or CAT-6 cable.
3 Do not strip off the end of the cable shield, but rather, twist the shield to form a braid.