Chapter 5: Installation
Installing the ODU
Page 5-5
Installing the ODU
To install the ODU, use the following procedures:
•
Attach ground cables to the ODU
on page
•
Attach ground cables to the ODU
1 Fasten one ground cable to each ODU grounding point using the M6 (small) lugs: one is for the
surge suppressor and the other is for the tower or building (M10 lug at other end). It does not
matter which cable goes on which ODU grounding point.
2 Tighten both ODU grounding bolts to a torque of 5 Nm (3.9 lb ft).
Mount the ODU on the mast
Refer to individual procedures below for mounting the PTP 550 ODU:
•
Low profile bracket on small diameter pole
•
Low profile bracket on large pole
2