Cambium Networks PMP 450 Series, Installation Manual

Page: 190 / 292

Chapter 4: Preparing for installation 190
l
Configuring security
l
Configuring radio parameters
l
Setting up SNMP agent
l
Configuring syslog
l
Configuring remote access
l
Monitoring the Link
l
Configuring quality of service
l
Zero Touch Configuration Using DHCP Option 66
l
Configuring Radio via config file
l
Configuring a RADIUS server
If the units are to be pre-configured during staging, the safety precautions below MUST be observed.
Pr ep ar ing p er sonnel
In no event shall Cambium Networks be liable for any injury or damage caused during the installation of the
Cambium 450 Platform Family ODU.
Ensure that only qualified personnel undertake the installation of a 450 Platform system.
Ensure that all safety precautions are observed.
Pr ep ar ing invent or y
Perform the following inventory checks:
l
Check that the correct components are available, as described in Ordering the components on
page 1.
l
Check the contents of all packages against their packing lists.
Pr ep ar ing t ools
Check that following specific tools are available, in addition to general tools:
l
RJ45 crimp tool (it must be the correct tool for the type of RJ45 being used).
l
Personal Computer (PC) with 10 or 100 or 1000 BaseT Ethernet port
l
Web browser
l
Ethernet patch cables
Test ing sy st em co m p o nent s
The best practice is to connect all components—AP/BHM, SMs/BHS, GPS antenna (if applicable) and CMM
(if applicable)—in a test setting and initially configure and verify them before deploying them to an
installation. In this way, any configuration issues are worked out before going on-site, on a tower, in the