Cambium Networks PMP 450 AP, Planning And Installation Manual

Page: 89 / 287

Chapter 2: System hardware Cabling
Page
2-39
SFP module kits
SFP module kits allow connection of a PMP 450 Series ODU to a network over an Optical Gigabit
Ethernet interface (1000BASE-LX or 1000BASE-SX) full-duplex mode.
Order SFP module kits from Cambium Networks ( Table 44 ).
Table 44 SFP module kit part numbers
Cambium description Cambium part number
Single Mode Optical SFP Interface per ODU C000065L008A
Multi-mode Optical SFP Interface per ODU C000065L009A
2.5GBASE-T Copper SFP Interface per ODU C000065L011A
To compare the capabilities of the two optical SFP modules, refer to Table 45 and Table 46 .
Table 45 Single Mode Optical SFP Interface per ODU (part number C000065L008)
Core/
cladding
(microns) Mode Bandwidth at
1310 nm (MHz/km) Maximum
length of optical
interface Insertion loss
(dB)
62.5/125 Multi 500 550 m (1800 ft) 1.67
50/125 Multi 400 550 m (1800 ft) 0.07
50/125 Multi 500 550 m (1800 ft) 1.19
10/125 Single N/A 5000 m (16400 ft) 0.16
Table 46 Multi-mode Optical SFP Interface per ODU (part number C000065L009)
Core/
cladding
(microns) Mode Bandwidth at
850 nm (MHz/km) Maximum
length of optical
interface Insertion loss
(dB)
62.5/125 Multi 160 220 m (720 ft) 2.38
62.5/125 Multi 200 275 m (900 ft) 2.6
50/125 Multi 400 500 m (1640 ft) 3.37
50/125 Multi 500 550 m (1800 ft) 3.56
The upgrade kits contain the following components:
• Optical SFP transceiver module ( Figure 28 )
•
Long EMC strain relief cable gland ( Figure 29 )
Note
PMP 450m supports Fiber SFPs from system release 15.0.3.