Cambium Networks PMP 450 AP, Configuration Manual

Page: 46 / 649

Chapter 1: Configuration Quick link setup
Page
1-18
12 Click the Reboot button.
RESULT: The AP responds with the message Reboot Has Been Initiated…
13 Wait until the indicator LEDs are not red.
14 Trigger your browser to refresh the page until the AP redisplays the General Status tab.
15 Wait until the red indicator LEDs are not lit.
Configuring time settings
Applicable products PMP:

AP PTP:

BHM
To proceed with the test setup, click the Configuration link on the left side of the General Status page.
When the AP responds by opening the Configuration page to the General page, click the Time tab.
Figure 7 Time tab of the AP/BHM
To have each log in the AP/BHM correlated to a meaningful time and date, either a reliable network
element must pass time and date to the AP/BHM or you must set the time and date whenever a power
cycle of the AP/BHM has occurred. A network element passes time and date in any of the following
scenarios:
• A connected CMM4 passes time and date (GPS time and date, if received).
•
A separate NTP server is addressable from the AP/BHM.
If the AP/BHM should obtain time and date from a CMM4, or a separate NTP server, enter the IP address
of the CMM4 or NTP server on this tab. To force the AP/BHM to obtain time and date before the first (or
next) 15-minute interval query of the NTP server, click Get Time through NTP.