Chapter 3: Operation
System statistics
Page
3-56
Table 138 MIR/Burst page attributes for AP
Attribute
Meaning
Subscriber
This field displays the LUID (logical unit ID), MAC address and Site Name of
the SM/BHS. As each SM or BHS registers to the AP/BHM, the system
assigns an LUID of 2 or a higher unique number to the SM/BHS. As of release
15.2, if an SM/BHS loses registration with the AP/BHM and then regains
registration, the SM/BHS retains the same LUID.
Current Downlink
Bucket Size
This field displays the number of bits in the bucket to be potentially
consumed at above-MIR rates, up to Max Burst MIR rate.
Downlink MIR
This field displays the active configured MIR rate per second. This is the rate
that the bucket is filled with bits.
Downlink MIR Per
500ms Interval
This field displays the rate that the bucket is filled with bits at every 500 ms
interval.
Downlink Max Bucket
Size
This field displays the configured maximum bucket size, which is the
maximum number of bits that can be in the bucket. The bucket fills at MIR
rate and can hold this number of bits, which is a configuration value.
Current Max Burst
Bucket Size
If Max Burst is enabled, there is a secondary “bucket” that controls the
maximum rate of bit consumption. If Max Burst is not enabled (which means
not limited), this will be 0 as the bucket is not used.
Downlink Max Burst
MIR
This field displays the configured value of the Max Burst rate. This is the
maximum rate at which bits can be consumed above MIR. Once excess (>
MIR) bits have been consumed, the link will be throttled to MIR.
Downlink Max Burst
MIR Per 500ms
Interval
This field displays the configured value of the Max Burst rate at every 500
ms interval.
Uplink MIR
This field displays the active configured MIR rate per second in the SM.
Uplink Max Bucket
Size
This field displays the configured maximum bucket size of the SM, which is
the maximum number of bits that can be in the bucket. The bucket fills at
MIR rate and can hold this number of bits, which is a configuration value.
Uplink Max Burst MIR
This field displays the configured value of the MaxBurst rate of the SM. This
is the maximum rate at which bits can be consumed above MIR. Once excess
(> MIR) bits have been consumed, the link will be throttled to MIR.
Summary of Contents for PMP 450 AP
