Cambium Networks PMP 450 AP, Configuration Manual

Page: 129 / 649

Chapter 1: Configuration Configuring Unit Settings page
Page
1-101
Unit Settings page of 450 Platform Family - AP/BHM
The Unit Setting page of AP/BHM is explained in Table 30 .
Table 30 Unit Settings attributes – 450 Platform Family AP/BHM
Attribute Meaning
Set to Factory
Defaults Upon Default
Mode Detection If Enabled is checked, then the default mode functions is enabled. When the
module is rebooted with Default mode enabled, it can be accessed at the IP
address 169.254.1.1 and no password, and all parameter values are reset to
defaults. A subscriber, technician, or other person who gains physical access
to the module and uses an override
cannot see or learn the settings that
were previously configured in it.
If Disabled is checked, then the default mode functions are disabled.
Caution
When Set to Factory Defaults Upon Default Mode is set to
Enable, the radio does not select all of the frequencies for Radio
Frequency Scan Selection List. It needs to be selected manually.
Undo Unit-Wide
Saved Changes When you click this button, any changes that you made in any tab but did
not commit by a reboot of the module are undone.
Set to Factory
Defaults When you click this button, all configurable parameters on all tabs are reset
to the factory settings.