www.calumetphoto.com
5
power port operation
1.
Turn off unit and disconnect cables.
2.
Remove battery cover by pressing down latch and pulling outward.
3.
With battery facing you, hold unit in both hands with thumbs covering battery.
4.
Push battery down and forward with thumbs to release battery from locking lip near
bottom of unit.
5.
Grasp yellow tab with thumb and index finger and pull to remove battery.
6.
While holding battery and unit, place unit down on flat surface.
7.
Carefully disconnect battery from housing cable.
8.
Replace battery by reversing steps listed above.
Switch off the Power Port unit and disconnect the connecting cable
and any battery charger. The fuse is located in the fuse case
(3)
located on the top of the unit’s control panel. Remove the cap of the
fuse case by pulling upward. You may need to pry upward using a
slotted screwdriver. Remove old fuse and replace it with one of the
same amperage/voltage rating and reinsert clip. One spare fuse is
included with the unit.
replacing or removing the battery
changing the fuse
The Power Port is equipped with a low-voltage protection alarm that is designed to protect
your equipment’s circuitry. The beeper will sound when the battery is less than 9.5 volts,
thus making the battery inoperable. You will need to charge or use spare battery (CF0512)
to continue operation.
NOTE: Turn off the power switch on the Power Port and Genesis
300 B flash Unit and remove the connecting cable PRIOR to charging or replacing battery.
low voltage protection
Steps are also printed on the cover of the battery compartment.
A
AC
C c
ch
ha
arrg
ge
err
D
DC
C c
ca
arr c
ch
ha
arrg
ge
err a
ad
da
ap
ptte
err
c
co
on
nn
ne
ec
cttiin
ng
g c
ca
ab
blle
e
C
Ca
allu
um
me
ett G
Ge
en
ne
es
siis
s 3
30
00
0 B
B
A
AC
C//D
DC
C F
Flla
as
sh
h U
Un
niitt
e
ex
xtte
erriio
orr h
ho
ou
us
siin
ng
g
Provides up to 200 Flashes
at Full Power!
NOTE: The total number of flashes
available will depend on the power
setting of the flash unit and the
condition of the battery.
Summary of Contents for Genesis B Power Port
Page 1: ...USER GUIDE...