Rejuvenation Series Spas
LTR50001131, Rev. A
Pr
eparing f
or
Your Ne
w P
or
tab
le Spa
www.calspas.com
7
Filling and Powering Up Your Portable Spa
Inspect the spa equipment .
1 .
Fill the spa .
3 .
Remove the cartridge from filter canister.
2 .
Place a garden hose in the filter canister and fill your spa
with
regular tap water
about six inches from the top.
Unscrew the cartridge and remove it.
After you remove the filter, remove the plastic wrapper and soak it in water for 30 minutes before you
replace it. A dry filter can allow air into the filtration system which can cause the pump to fail to prime.
After the spa has been placed on an approved surface and
has been correctly wired by a licensed electrician, inspect
all plumbing connections in the equipment area of your spa.
Ensure that these connections are secure and that they did
not loosen during shipment.
If your spa has gate valves, make sure they are all in the
UP or OPEN position.
Never run the spa with the gate valves closed or without
water circulating for long periods of time. Be careful not to
over-tighten the plumbing fittings.
Always fill the spa through the filter canister! Failure
to do so may cause air to be trapped in the filtration
system and prevent the pumps from operating
properly.
If the water level is too low or too high, your spa will
not operate properly.
Never fill your spa with soft water.
Soft water makes it impossible to maintain the proper water chemistry and may cause the water to foam,
which will ultimately harm the finish of the spa and void your warranty.
Summary of Contents for Rejuvenation Fountain of Youth
Page 1: ...LTR50001131 Rev A 1 2 13 ...