2013 Portable Spa
LTR20131000, Rev. E
Operating
Your Spa
www.calspas.com
25
Invert Panel
Selecting Invert Panel will fl ip the display and the
buttons so the panel can be easily operated from
inside or outside the hot tub.
Lock
The control can be restricted to prevent unwanted
use or temperature adjustments.
Locking the Settings
•
allows jets and other features
to be used, but the set temperature and other
programmed settings cannot be adjusted.
When settings are locked, there is a reduced
selection of menu items. These include Set
Temperature, Invert, Lock, Utilities, Information
and Fault Log. They can be seen, but not changed
or edited.
Locking the Panel
•
prevents the controller from
being used, but all automatic functions are still
active.
Lock
Back
Settings
Panel
OFF
OFF
Lock
Back
Settings
Panel
OFF
ON
Set: 104°F
8:32 PM
Ozone
Filter 1
Unlock
High Range
102°F
Ready in Rest Mode
Heating
Unlocking
-- An unlock sequence using the
navigation buttons can be used from the Lock Screen.
The Unlock Sequence is the same for both Panel Lock
and Settings Lock.
Press:
Twice
Then
Press:
Once
Hold
Hold Mode is used to disable the pumps during
service functions like cleaning or replacing the fi lter.
Hold Mode will last for 1 hour unless the mode is
exited manually. If spa service will require more than
an hour, it may be best to simply shut down power
to the spa.
Utilities
This menu feature is for system information only and
is used mainly for repair and troubleshooting.
Preferences
This allows you to set the following preferences for
system operation:
Change the temperature between Fahrenheit
•
and Celsius
Change the clock between 12-hour and 24-hour
•
display
Turn periodic reminded (like “CLEAN FILTER”) on
•
or off
Information
This menu feature is for system information only and
is used mainly for repair and troubleshooting.
Circulation Mode (See Page 8, under
Pumps, for other circulation modes)
If the spa is configured for 24HR circulation, the
heater pump generally runs continuously. Since the
heater pump is always running, the spa will maintain
set temperature and heat as needed in Ready Mode,
without polling. In Rest Mode, the spa will only heat to
set temperature during programmed filter times, even
though the water is being filtered constantly when in
Circulation Mode.
Ready-in-Rest Mode
READY/REST appears in the display if the spa is
in Rest Mode and the Jets 1 Button is pressed. It is
assumed that the spa is being used and will heat to
set temperature. While Pump 1 High can be turned
on and off, Pump 1 Low will run until set temperature
is reached, or 1 hour has passed. After 1 hour, the
System will revert to Rest Mode. This mode can also
be reset by entering the Settings Menu and changing
the Heat Mode.
Lock
Back
Settings
Panel
OFF
OFF
Lock
Back
Settings
Panel
OFF
ON
Set: 104°F
8:32 PM
Ozone
Filter 1
Unlock
High Range
102°F
Ready in Rest Mode
Heating
Summary of Contents for F1239
Page 1: ...LTR20131000 Rev E 9 18 13 ...
